Compatible Remote Controllers and Remote Switches (Still Images/Movies) (EOS 5D Mark IV)
08-Jul-2016
8203014200
Solution
You can connect the Remote Switch RS-80N3, Timer Remote Controller TC-80N3 (both sold separately), or any EOS accessory equipped with an N3-type terminal to the camera for shooting.
| Remote Controller RC-6 | Timer Remote Controller TC-80N3 | Remote Switch RS-80N3 | Wireless Controller LC-5 |
 |  |  |  |
NOTE
- You can also use Remote Controller RC-1 and RC-5.
- Remote control shooting is also possible with devices such as an EXseries Speedlite equipped with a remote-release function (sold separately).
- To operate the accessory, refer to its instruction manual.
1. Open the terminal cover.
2. Connect the plug as shown in the illustration.
To disconnect the plug, grasp the silver part and pull.
With Remote Controller RC-6 (sold separately), you can shoot remotely up to approx. 5 meters/16.4 feet away from the camera (when you are facing the front of the camera). You can either shoot immediately or with a 2-sec. delay.
1. Set the power switch to <ON>.
2. Focus the subject.
3. Set the lens focus mode switch to <MF>.
You can also shoot with <AF>.
4.Press the <DRIVE・AF> button.
5.While looking at the LCD panel or in the viewfinder, turn the Quick Control Dial <
> to choose 10-sec. self-timer/remote control shooting [ 
] or 2-sec. self-timer/remote control shooting [ 
].
> to choose 10-sec. self-timer/remote control shooting [ ] or 2-sec. self-timer/remote control shooting [ ].
6.Point the remote controller toward the camera's remote control sensor and press the transmit button.
The self-timer lamp lights up and the picture is taken.
Remote control sensor
IMPORTANT
- Fluorescent or LED lighting may cause camera misoperation by triggering the shutter inadvertently. Try to keep the camera away from such light sources.
- If you point a remote controller for a TV set toward the camera and operate it, it may cause camera misoperation by triggering the shutter inadvertently.
- If flash light is emitted from a flash on another camera around this camera, it may cause camera malfunction by triggering the shutter inadvertently. Do not expose the remote control sensor to flash light from a flash on another camera.
NOTE
Notes for Movie Shooting
- When [Enable] is set, you can start or stop movie shooting using Remote Controller RC-6 (sold separately). Set the RC-6’s release mode switch to <2>, then press the transmit button. If the switch is set to <
> (immediate release), the <
btn function> setting will be applied. - If [
] or [ 
] is set under the <btn function> setting, besides pressing the <
> button, you can start or stop the movie shooting by pressing the shutter button completely or by using Remote Switch RS-80N3 or Timer Remote Controller TC-80N3 (each sold separately).