Zooming in Closer on Subjects when Shooting (PowerShot SX540 HS)

Last Updated : 07-Jan-2016
Issue Number : 8202796800

Solution

IMPORTANT

The instructions in this section apply to a camera with the [Shooting Mode] set to [AUTO].

When distant subjects are too far away to enlarge using the optical zoom, follow the instructions below.

Introduction

When distant subjects are too far away to enlarge using the optical zoom, use digital zoom for up to about 200x enlargement.

Shooting Mode with a Digital Zoom Limit

Using Digital Zoom

1. Press the [MENU] button, select the [

] tab and set [Digital Zoom] to [On].

2. Move the zoom lever toward [

] and hold it until zooming stops.

Zooming stops at the largest possible zoom factor (before the image becomes noticeably grainy), which is then indicated on the screen.

3. Move the zoom lever toward [

] again.

The camera zooms in even closer on the subject.
is the current zoom factor.

IMPORTANT

Moving the zoom lever will display the zoom bar, which indicates the zoom position. The color of the zoom bar will change depending on the zoom range.

--White range: optical zoom range where the image will not appear grainy.

--Yellow range: digital zoom range where the image is not noticeably grainy (ZoomPlus).

--Blue range: digital zoom range where the image will appear grainy.

Also, because the blue range will not be available at some resolution settings, you can zoom in to the maximum zoom factor.

NOTE

The focal length that combines the optical zoom and the digital zoom is 24 - 4800 mm (35 mm film equivalent). (The focal length for the optical zoom is 24 - 1200 mm.)
To deactivate digital zoom, choose [MENU] > [Shooting] tab ( ) > [Digital Zoom] > [Off].

Using ZoomPlus

Depending on the resolution settings and the digital zoom factor, the [Zoom Bar] will be displayed in yellow [

] (ZoomPlus).

In order to avoid image deterioration when shooting with [Digital Zoom], shoot within the range of ZoomPlus.

Digital Tele-Converter

With the digital tele-converter, the focal length of the lens can be increased by approximately 1.6x or 2.0x. This can reduce camera shake because the shutter speed is faster than it would be if you zoomed in (including using digital zoom) to the same zoom factor.

Shooting Mode with a Digital Tele-Converter Limit

1. Press the [MENU] button, choose the [

] tab, and then set [Digital Zoom] to either [1.6x] or [2.0x].

IMPORTANT

The digital tele-converter cannot be used with digital zoom or point zoom.

NOTE

The focal length for a 1.6x increase or a 2.0x increase is 38.4 - 1920.0 mm and 48.0 - 2400.0 mm respectively (35 mm film equivalent).
The shutter speed may be equivalent when you move the zoom lever all the way toward [ ] for maximum telephoto, and when you zoom in with [Digital Zoom] to enlarge the subject to the same size.