Setting the IP Address (IP v. 4) (LBP6030w)

29-May-2014
8202086500

Solution

    The machine's IPv4 address can be either assigned automatically by a dynamic IP addressing protocol, such as DHCP, or entered manually.

    1. Start the Remote UI and log on in System Manager Mode.

    2. Click [Settings/Registration].

    3. Click [Network Settings] [TCP/IP Settings].

    4. Click [Edit] in [IPv4 Settings].

    5. Set the IP address.

    Automatically assigning an IP address
    5-A-1. In the [Select Protocol] list, select [DHCP], [BOOTP], or [RARP].
    NOTE:
    If you do not want to use DHCP/BOOTP/RARP to assign an IP address automatically
    • Select [Off]. If you select the [DHCP], [BOOTP], or [RARP] protocol when these services are unavailable, the machine will waste time and communications resources searching the network for these services.

    5-A-2. Check that [Auto IP] is set to [On].
    • If [Off] is selected, change the setting to [On].
    NOTE:
    Even if Auto IP is enabled, IP addresses assigned via DHCP/BOOTP/RARP override an address obtained via Auto IP.

    Manually entering an IP address
    5-B-1. Select [Off] for [Select Protocol] and [Auto IP].
    5-B-2. Set the [IP Address], [Subnet Mask], and [Gateway Address] fields.

    6. Click [OK].

    7. Restart the machine.
    • Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
    NOTE
    Checking whether the settings are correct
    • Make sure that the Remote UI screen can be displayed with your computer.
    If you change the IP address after installing the printer driver
    • If you are using an MFNP port, and the machine and the computer are in the same subnet, then the connection will be maintained. You do not need to add a new port. If you are using a standard TCP/IP port, then you need to add a new port.

    Related Information