How to switch the paper source (DOS, UNIX, etc.)
18-Jul-2012
8201608400
Issue
When you are printing from DOS, UNIX, or other operating system on which you cannot use the printer driver, select a paper source using the control panel. The default setting for this printer's paper source is set to AUTO.
Select a paper source with the printer's control panel using the following procedure.
NOTE
Clarifications of the operation and additional explanations for the procedure are indicated at the end of this page. Reading these notes is highly recommended.
Cause and Solution
1. Move to the printer, then press 
on the control panel.
on the control panel.
PAPER SOURCE is displayed in the display.
2. Select PAPER SOURCE using 
and 
, then press 
.
and , then press . 
3. Select the paper source using and , then press .
and , then press .
NOTE
a. CASSETTE 2 is displayed only when the paper feeder is installed.
b. If paper of the same size is loaded in two or more paper sources when the paper source setting is specified to be selected automatically, paper is fed from the upper paper source regardless of the status of the paper source indicators. When the paper source runs out of paper, the paper source automatically switches to other one in which paper of the same size is loaded.