How to set Continuous Shooting

    13-May-2010
    8200800000

    Solution

      You can shoot continuously at a maximum speed of approximately 3.7 images/second while the <shutter button> is pressed fully and held. (When shooting continuously in [Low Light] () mode, the maximum speed is approximately 6.0 images/second)
      CAUTION
      • For continuous shooting, the focus and exposure are locked when the <shutter button> is pressed halfway.
      • For a certain interval, images may not be recorded, and the shooting speed for may slow down depending on the shooting conditions and the camera settings.
      • As the number of images increases, the shooting speed may slow down.
      • If the flash fires, the shooting speed may slow down.
      • In the following shooting modes, you cannot set the [Continuous Shooting] ().
      - [AUTO] (), [Smart Shutter] (), [Stitch Assist] (), [Movie] ()

      1. Set the <Mode Switch> to [Shooting] () and then press the <Power> button.




      2. Press the <FUNC./SET> () button.




      3. The following screen appears on the LCD monitor.



      Operate the <directional buttons> up or down to select the [Single Shot] ().
      Press the <FUNC./SET> () button.


      4. The following screen appears on the LCD monitor.



      Operate the <directional buttons> up or down to select the [Continuous Shooting] ().
      Press the <FUNC./SET> () button.


      5. The following screen appears on the LCD monitor.



      If the [Continuous Shooting] () icon is displayed on the upper-left part of the screen, the setting is completed.
      As long as you hold the <shutter button> down, the camera will shoot successive images.


      NOTE
      • Continuous shooting speed increases in [Low Light] () mode. (Approx. 6.0 images/sec.)
      - To set the shooting mode to [Low Light] () , follow the instructions below.
      1. Set the <Mode Switch> to [Shooting] ().
      2. Press the <FUNC./SET> () button.
      3. Operate the <directional buttons> up and down to select [Shooting Mode]. ([Program AE] () appears if settings have not been changed before.)
      4. Press the <FUNC./SET> () button.
      5. Operate the <directional buttons> up and down to select [Low Light] ().
      6. Press the <FUNC./SET> () button.