Solution
When setting [Flash] to [Auto], [Flash] is not activated if the surroundings are light. However, when shooting with the subject backlit, [Flash] is sometimes used not to make the subject dark. This section describes the setting to shoot the shots with constant flash.
IMPORTANT
- The following explanations are provided based on the assumption that the [Shooting Mode] is set to [Program AE] (
).
- In the following shooting modes, you cannot set the [Flash] to the On setting to make it fire every time you shoot.
- [AUTO] (
) , [High-speed Burst HQ] (
) , [Fireworks] (
) , [High Dynamic Range] (
) , [Movie] (
) , [iFrame Movie] (
) , [Super Slow Motion Movie] (
)
1. Press the <Power> button on the camera.
2. Press the <Flash> button (
).
3. The following screen will appear in the LCD screen.
Operate the <directional buttons> to select the [Flash On] (
).
Make sure to select [On].
4. If the following icon is displayed on the monitor, this completes the setting process.
NOTE
- You can also configure this setting by pressing the <
> button, touching ], and then touching it again.
- If the flash is down, it will be raised automatically.
