Inspection Checklist for the Power Cord and Power Plug - Canon India

  1. Notices
  2. Inspection Checklist for the Power Cord and Power Plug
Contact Us

18 Jan 2007

    Inspection Checklist for the Power Cord and Power Plug

    Contact the local Canon Service Centres if any of the following problems are found:

    • There are burn marks on the power plug. It is possible that tracking phenomena have started. This is a dangerous condition.

    • A power plug prong is deformed.


    • The power supply goes off and on when the power cord is bent.

    • There are cuts, cracks, or indentations on the power cord.


    • A portion of the power cord becomes hot.






    Examples that may cause electric shock or fire and are dangerous:

    • Dust or debris has accumulated on the power supply outlet and power plug. 
      (Recommendation: Turn the power switch off, disconnect the power plug, and remove dust and debris with a dry cloth.)

    • The connector on the device side is loose.
      (Recommendation: Push the connector firmly all the way in.)


    • Stress is being applied to the power cord. 
      (Recommendation: Position the power cord so that it is not subjected to stress.)


    • Disconnecting the plug by pulling on the power cord. 
      (Recommendation: Always disconnect the power plug by pulling on the plug rather than the cord.)

    • Connecting or disconnecting the power plug with wet hands. 
      (Recommendation: Dry your hands completely with a towel, etc., before connecting or disconnecting the power plug.)


    • The power plug is loose. 
      (Recommendation: Push the power plug firmly all the way in.)

    • The power cord is tied in a bundle. 
      (Recommendation: Loosen the power cord.)


    • The power cord protrudes into a walkway. 
      (Recommendation: Position the power cord so that it will not obstruct the walkway.)

    • The power cord is in front of a heater. 
      (Recommendation: Position the power cord in a location that is not subjected to heat radiation.)


    • The product or table tap is at a location near water access. 
      (Recommendation: Water is the enemy of electricity. Do not use electrical products at a location on which water may come.)

    • An excessive number of cords are connected. It is possible that the rated capacity of the table tap has been exceeded. 
      (Recommendation: Do not connect an excessive number of cords.)


    Back to top

    Company

    Products

    Services

    Your Canon + You

    Support & Downloads

    Copyright © 2024 Canon India Pvt Ltd. All rights reserved.