How to set Continuous Shooting

    20-Apr-2012
    8201443800

    Solution

      You can shoot continuously while the <shutter button> is pressed fully and held.
      The number of shots that can be taken in 1 second is as shown in the table below.
      ModelRecordable Shots ( / sec.)
      PowerShot ELPH 110 HS / IXUS 125 HSApprox. 2.0 shots
      PowerShot D20Approx. 1.9 shots

      IMPORTANT
      • The following explanations are provided based on the assumption that the [Shooting Mode] is set to [Program] ().
      • Cannot be used with the self-timer or [Blink Detection].
      • During continuous shooting, focus and exposure are locked at the position/level determined when you pressed the shutter button halfway.
      • Shooting may stop momentarily or continuous shooting may slow down depending on shooting conditions, camera settings, and the zoom position.
      • As more shots are taken, shooting may slow down.
      • Shooting may slow down if the flash fires.
      • In the following shooting modes, you cannot set the [Continuous] ().
      - [AUTO] (), [Movie Digest] (), [Smart Shutter] (), [Handheld NightScene] (), [Long Shutter] (), [Stitch Assist] (), [iFrame Movie] (), [Super Slow Motion Movie] ()

      1. Press the <Power> button.


      2. Press the <FUNC./SET> () button.


      3. The following screen appears on the LCD monitor.



      Operate the <directional buttons> up or down to select the [Drive Mode] ().
      After the selection is made, press the <FUNC./SET> button ().


      4. The following screen appears on the LCD monitor.



      Operate the <directional buttons> up or down to select the [Continuous] ().
      After the selection is made, press the <FUNC./SET> button ().


      5. The following screen appears on the LCD monitor.



      If the [Continuous] () icon is displayed on the upper-left part of the screen, the setting is completed.
      As long as you hold the <shutter button> down, the camera will shoot successive images.
      NOTE
      If using the PowerShot ELPH 110 HS / IXUS 125 HS, when shooting with Face ID set to [Continuous] (), the location in the image where the name is recorded will be determined in the first shot, and will be recorded in the same place for further shots.